Shape WLB Paparazzi Handle for Canon C100 C300 C500

C100 / C300 / C500 Paparazzi Handle

C100 / C300 / C500 15mm base

The SHAPE C300 Baseplate is made specifically for the Canon EOS C100 C300 C500 cameras. This camera accessory provides a small, light setup solution expandable to a more elaborate setup. It features a pair of 15 mm rods that are 12" long through the length of the baseplate.

Key Features:

• Specifically, for Canon C100/C300/C500
• Baseplate mounts 15 mm rods
• Ergonomic Handle parallel with the camera
• Baseplate designed with spring-Loaded Locking Levers
• Handle features several 1/4″-20 & 3/8″-16 threaded Holes
• The 1/2″ holes let you screw in male-threaded rods
• Takes on lights, monitors, mics, grips, remote, recorders, arms, receivers, rods
• Fully solid and water / laser cut
• Holes run completely through from end to end

The baseplate attaches underneath the camera with 4 x M4 screws or with 3/8”-16 and 1/4”-20 screws that are included. The baseplate maintains the proper lens center to the rod height for use with available rod mounted accessories. This allows you to use available standard follow focus units, zoom motors, and matte boxes with your camera while using the baseplate.

Paparazzi w/Bloc

The SHAPE Paparazzi with Bloc is an ergonomic-designed Paparazzi Handle screwed tight to a Rod Bloc by two 1/4" screws. The Handle features a total of 20 screw-holes for attaching accessories, and the Bloc mounts 15mm rods and keeps the Handle parallel with a camera. You can slide the Bloc up and down the rods and tighten it into position by a red lever on the side. Both the Handle and Bloc are totally solid -- not at all hollow -- and are both water cut / laser cut, as opposed to being molded.

The 20 screw-holes are a mix of 1/4", 3/8" and 1/2" sizes and all run completely through from end to end. They are positioned vertically or horizontally along the Handle. The 1/4" and 3/8" holes can take on most any 1/4" and 3/8" accessories like lights, monitors, mics, grips, remote controls, recorders, articulating arms, wireless audio receivers, camera plates, and more. And into the 1/2" holes you can screw in male-threaded SHAPE rods (2ROD15MF4, 2ROD15MF6) . The diverse set of screw-holes lets you get very creative in dressing up your rig. And the ability to screw in rods lets you just as creatively extend your rig.

15mm 12" rods

One pair of SHAPE 15-mm aluminum rods for your compatible camera rig. Mount any 15-mm compatible accessories and form the support structure of your rig.

• 15-mm diameter
• 12-in length
• Hollow, non-threaded
• Tapered ends for easy connection to a rod block
• Aluminum coated with a clear finish